Zopf offer the ZB70 range for tubes up to 70mm diameter. Each machine is supplied complete with a full set of plates and spacers for setting up toolng to suit flat bar, square section, hollow section etc. Rollers can be machined in steel or polyamide for round tube.
Faster and less expensive than conventional cleaning methods
The most versatile cleaning machine on the market
Proven track record within the welding industry
Cleaning
The Bymat will easily remove the oxide film from the weld
quickly, cleanly and safely. Simply dip the pad or brush into the Electrolytic
cleaning solution and wipe across the weld. The oxide film instantly disappears
and the welded area is simultaneously protected against corrosion (passivated)
in one operation. In comparison with cleaning and pickling with acids, this
process is significantly faster and less expensive due to zero waiting time.
The chemicals used for the process contains no hazardous substances and so is
significantly safer than conventional chemical cleaning methods.
Electropolishing
The grey edge marks (heat-affected zones) close to the
welded seams are caused by the material changes during the welding process.
These can be removed without any problem using the “Polish” setting on the
machine. It is possible to polish stainless steel to a high gloss finish thus
returning the original lustre of the material.
Dark marking of electrically - conductive surfaces
Dark marking onto Stainless Steel can be performed using a
template/stencil designed to your specific requirements.
The Bymat will permanently mark components deep black,
easily, rapidly and inexpensively. Once marked the text or design cannot be
removed by cleaning products or solvents and will not wear off. Company logos,
graphics, trademarks, serial numbers, identification numbers, scales, and texts
can be permanently marked.
Our high-performance electrolyte is PH neutral and requires
no neutralization.
Light marking of electrically - conductive surfaces
Light marking uses the same template/stencil as for dark
marking. Using a different Electrolyte we achieve a light marking effect
similar to engraving. Material is removed from the component leaving your
design/text permanently etched into the surface. This is suitable for materials
such as black steels and aluminium for example.
Electroplating / metal plating
With this process it is possible to electroplate small areas
of a component using any material which can be liquefied. For examples
zinc-plating as corrosion protection after welding. Possible metal coatings:
Tin, Zinc, Gold, Silver, Nickel, Chrome, Cadmium, Cobalt, Copper, Brass.
The machine is CE marked and is manufactured to meet all
applicable EU directives
